Quote:
Originariamente inviato da x9drive9in
Non tenere l'hdd al contrario...
|
E' un test per adesso, però ti assicuro che non c'è nessun problema a tenerlo in quel modo, mi sono informato sul sito "Segate", e dice chiaramente:
""Drive mounting
You can mount the drive in any orientation using four screws in the side-mounting holes or four screws in the bottom-mounting holes. See Figure 5 for drive mounting dimensions. Follow these important mounting precautions
when mounting the drive:
•Allow a minimum clearance of 0.030 inches (0.76 mm) around the entire perimeter of the drive for cooling.
•Use only 6-32 UNC mounting screws.
•The screws should be inserted no more than 0.150 inch (3.81 mm) into the bottom or side mounting holes.
•Do not overtighten the mounting screws (maximum torque: 6 inch-lb).""